watering

Orchid Water Quality Depends on More Than a TDS Reading

Water carries dissolved material into every orchid pot. Some of it supplies nutrients; some can accumulate around roots or change the acidity of the medium. A clear glass of tap water can therefore be quite different from rainwater or reverse osmosis water, even when all three look the same.

The right choice depends on the analysis of the water and the plants being grown. Many common orchids can do well with suitable tap water, while salt-sensitive plants may need a cleaner supply. Measuring first is more useful than treating every tap as if it produces the same water.

What a meter can tell you

An electrical conductivity meter estimates how readily a solution conducts electricity. Dissolved ions increase conductivity, so EC is useful for comparing the water entering a collection with the solution after fertiliser has been added. A TDS meter generally converts conductivity into an estimated concentration; its conversion factor matters when comparing numbers between meters.

Neither reading identifies the individual ions. Two samples with similar EC can have different proportions of calcium, sodium, bicarbonate or other substances. If the supply is suspect, a water analysis or utility report can give a better picture. For well water, a laboratory test can be particularly useful because composition varies with the source.

Alkalinity is a separate question. It describes the water’s ability to neutralise acid, largely from bicarbonates and carbonates. High alkalinity can push the pH of a growing medium upwards over time and affect nutrient availability. The pH of a fresh water sample alone does not tell you how strongly it is buffered.

Tap water, rain and reverse osmosis

Tap water is convenient and can be suitable where its mineral and salt content is modest. Test the actual supply rather than assuming a regional hardness map describes the water at the tap. A utility can change sources or treatment, and well water can differ greatly between properties.

Avoid water from a sodium-exchange household softener. It reduces hardness by exchanging minerals for sodium, which can accumulate in a pot. A drinking-water filter intended mainly to improve taste should not be assumed to remove dissolved salts either.

Rainwater is often low in dissolved minerals, but its quality depends on the collection surface and storage. Keep containers clean and avoid runoff from materials that could introduce contaminants. Reverse osmosis removes much of the dissolved material and gives a grower a more consistent starting point, though the membrane needs maintenance. Check its output periodically: a rising EC can signal that performance has changed.

Very low mineral water is not a complete feeding programme. Plants need nutrients, including calcium and magnesium, supplied in appropriate amounts. Fertiliser choice and concentration should take the starting water into account. Low-alkalinity water also has little buffering capacity, so its pH can change readily when fertiliser is added.

Watch the pot as well as the water

Fertiliser contributes salts too. White or brown crusts on the medium or pot can indicate accumulation; damaged roots have several possible causes, so inspect the plant and the mix before deciding that salts are responsible. A medium that has broken down and stays wet can also deprive roots of air.

Water thoroughly when the plant needs it, letting water run freely through drainage holes and allowing the pot to drain. This helps move accumulated salts out of the medium. Do not leave the pot standing in its runoff. Frequency still depends on the plant, pot, medium and growing environment.

A useful routine is to record the EC of the source water, then the solution after fertiliser is mixed, and compare them over time. A runoff reading can prompt further investigation, but it is affected by how the sample is collected and is not a full analysis of the root zone. Consistent measurements, a water report and a close look at the roots are more valuable together than any one number on a meter.